Network | Virtual Interface | Create

This section explains how to create a virtual interface and the different options available.

Create Virtual Interface

Find below the detailed options available while creating a virtual interface.

zevenet network virtual interface create

Parent Interface. Set a NIC, Bonding or VLAN interface as the parent interface, the Virtual Interface will be configured over it.
Name. Set a name to identify the new Virtual Interface, the name starts with the name of the Parent Interface followed by the virtual interface name ID to be used, and they are separated with a colon character. The parent interface name plus 1 plus the name set must be lower than 16 as defined by the system.
IP Address. Set the network-layer IP address to the new virtual interface. Netmask and Gateway will be inherited from the parent interface. The address can only be in the same network as its parent. Support IPv4 or IPv6

Once all the required configuration is set, press the Create button to create the new virtual interface.

Share on:

Documentation under the terms of the GNU Free Documentation License.

Was this article helpful?

Related Articles